HYS=DISABLE_, INV=INPUT_NOT_INVERTED_, OD=DISABLE_, SLEW=STANDARD, MODE=INACTIVE_NO_PULL_DO, FUNC=P4_29
I/O configuration register for pin P4[29]
| FUNC | Selects pin function for pin P4[29] 0 (P4_29): General purpose digital input/output pin. 1 (EMC_BLS3): LOW active Byte Lane select signal 3. 2 (U3_RXD): Receiver input for UART3. 3 (T2_MAT1): Match output for Timer 2, channel 1. 4 (I2C2_SCL): I2C2 clock input/output (this pin does not use a specialized I2C pad). 5 (LCD_VD_7): LCD data. 6 (LCD_VD_11): LCD data. 7 (LCD_VD_3): LCD data. |
| MODE | Selects function mode (on-chip pull-up/pull-down resistor control). 0 (INACTIVE_NO_PULL_DO): Inactive (no pull-down/pull-up resistor enabled). 1 (PULL_DOWN_RESISTOR_E): Pull-down resistor enabled. 2 (PULL_UP_RESISTOR_ENA): Pull-up resistor enabled. 3 (REPEATER_MODE_): Repeater mode. |
| HYS | Hysteresis. 0 (DISABLE_): Disable. 1 (ENABLE_): Enable. |
| INV | Invert input 0 (INPUT_NOT_INVERTED_): Input not inverted (HIGH on pin reads as 1, LOW on pin reads as 0). 1 (INPUT_INVERTED_HIGH): Input inverted (HIGH on pin reads as 0, LOW on pin reads as 1). |
| RESERVED | Reserved. |
| SLEW | Driver slew rate 0 (STANDARD): Standard mode, output slew rate control is enabled. More outputs can be switched simultaneously. 1 (FAST): Fast mode, slew rate control is disabled. Refer to the appropriate specific device data sheet for details. |
| OD | Open-drain mode. 0 (DISABLE_): Disable. 1 (OPEN_DRAIN_MODE_ENAB): Open-drain mode enabled. This is not a true open-drain mode. Input cannot be pulled up above VDD. |
| RESERVED | Reserved. |